Queen Reloading Neck Turning Too - QUEEN

It is the basic tool to start with the world of turning! Thanks to her
simplicity, it is very intuitive to use, the adjustment is made by acting on
a fine-pitch Allen screw that will move the tool by varying the amount of material to be removed. This is fully accomplished
with CNC machining centers, using erga of the best quality ensuring
very close tolerances and almost perfect flatness. Comes standard
with 30' cutting edge, the pilots used are Sinclair or similar with diameter
9.5mm. Thanks to the perfect centering of the pilot, this lathe can
be mounted on a parallel lathe chuck and then run
a faster but above all quality turning. On the opposite side a
that of the cutting edge a seat has been obtained for the comparator which there
will allow a real-time verification of the measurement.
(pilot and comparator not included in the price)